I have a model railway interest in N and OO gauge but also the electronics side.

Being a member of the MERG group has made me more then capable of using a soldering iron on small components as shown in the following photos.

ALL IMAGES ARE CLICKABLE

Test Board for testing new modules prior to fitting on Layout this board has Can Usb ( for programming ), Can Servo ( to drive Servos for point switching0 , CanVout ( to give outputs for accessories), 2 x Can Mio’s ( also for driving points , or Led ligts ) and a Can Pan ( for switching and led’s, ie Panel control) , with test board on top ,Showing switches and led’s .A relay board is also shown for frog polarity changing Mid point .

Arduino Uno for controlling Relays switching

Arduino Uno Controlling servos to switch points and Led’s to indicate Point direction. The Push buttons can also be programmed to select a route.

Arduino for controlling servos for point switching and LED’s for identification of train direction

Ezybus controller for Point motors and Control lights

Arduino Nano ( micro controller ) controlling lights ( Led’s ) for signal control Or This could be used to control lights inside a building.

A Test board for the Train Detection system (Merg modules ) for the new Bury layout . This test board has Can USB ( for programmining). The LH board is the one that is used to detect trains on track ( 8 inputs possible ) , This board sends its signal to a Can Imp board , ( this board convert the signal to a CBUS message ) and supplies this message to a CanVout board which will put an LED in the control panel to indicate a train on the track ) . We plan to use this as it reduces the number of wires , only 2 buss wires which are already going into the panel , from the track detection module.